| Introduction |
| Begin a new simulation |
| Open/Save simulations |
| Make a circuit look right |
| Add graphs |
| Run a simulation |
| State variables |
| Miscellaneous options |
Advanced features
Set break points on node voltages
This feature extends the capabilities of MoHAT by allowing you to set breakpoints on node voltages. You can set a voltage range that MoHAT will monitor, and, whenever a node voltage enters that range, it will change the color of the node and stop the simulation. You can set up to two voltage ranges, each with a lower and an upper bound, that will be watched. To set these ranges, click on the link in the control menu called Miscellaneous: Preferences. The top section of this window has text boxes that allow you to set the range to watch and a couple of options. These options control whether the simulation, if it's running in "play" mode, will stop when a node voltage either enters or exits the specified ranges. Leaving a box blank indicates that it will not check for that constraint. To make your changes take affect, you must close the preferences window.
